Intro: Damp patches look worrying, but the cause is often simple. 1. Check for leaks Pipes behind the wall may be dripping. 2. Improve ventilation Condensation can cause damp spots. 3. Check guttering Overflowing gutters cause damp walls. 4. Look for rising damp Moisture from the ground leaves a tide mark. 5. When to get … Read more
Intro: A slow‑draining sink is usually caused by a blockage close to the top of the pipe. 1. Clean the plug Hair and soap scum build up quickly. 2. Use boiling water Helps break down grease. 3. Use a plunger Creates pressure to clear blockages. 4. Check the U‑bend Unscrew it and remove debris. 5. … Read more
Intro: Condensation is common, but too much can cause mould. 1. Improve ventilation Open windows or use extractor fans. 2. Avoid drying clothes indoors This adds moisture. 3. Use a dehumidifier Helps reduce moisture quickly. 4. Check window seals Damaged seals let cold air in. 5. When to replace windows If condensation appears between the … Read more
Intro: An oven that won’t heat properly is frustrating, but the cause is often simple. 1. Check the temperature setting Make sure it’s not set too low. 2. Check the heating element If it’s not glowing, it may be faulty. 3. Check the door seal A damaged seal lets heat escape. 4. Restart the oven … Read more
Intro: Weak shower pressure is usually caused by blockages or simple maintenance issues. 1. Clean the shower head Limescale blocks the holes. 2. Check for kinks in the hose Straighten or replace it. 3. Check other taps If all taps are weak, it’s a supply issue. 4. Check boiler pressure Low pressure affects hot water … Read more
Intro: Flickering lights are annoying, but the cause is often simple. 1. Check the bulb Loose or faulty bulbs flicker. 2. Check the switch Worn switches cause intermittent contact. 3. Check the fitting Loose connections inside the fitting can flicker. 4. When to call an electrician If multiple lights flicker at once. Summary: Most flickering … Read more
Intro: A running toilet wastes water and money, but the fix is usually simple. 1. Check the flapper valve If it’s worn, water keeps flowing. 2. Adjust the float If it’s too high, water overflows internally. 3. Check the fill valve Debris can stop it shutting off. 4. When to call a plumber If the … Read more
Intro: A door that won’t close properly is usually caused by alignment issues. 1. Tighten the hinges Loose screws cause sagging. 2. Check for swollen wood Humidity can make doors swell. 3. Adjust the latch plate Move it slightly so the latch lines up. 4. Check for obstructions Carpets or debris can block the door. … Read more
Intro: A dripping tap is annoying and wastes water, but the fix is usually simple. 1. Replace the washer The most common cause. 2. Check the O‑ring If the drip is from the base, this is often the culprit. 3. Tighten the tap head Sometimes it just needs tightening. 4. When to call a plumber … Read more
Intro: A cold radiator doesn’t always mean a big problem. Most fixes are quick and simple. Here’s what to check before calling anyone out. 1. Bleed the radiator Air trapped inside stops hot water circulating. 2. Check the thermostatic valve Turn it fully on and off to free it if it’s stuck. 3. Check boiler … Read more